کابل ۵۳۰ ام تی سیسکو قابلیت اتصال مودمهایی نظیر ست مودم ماهواره ای Spl-2048 را به سریال Wic-1T میسر می سازد این کار در مودمهایی صورت میگیرد که قابلیت روتر نداشته و خروجی اترنت در اختیار کاربر قرار ندهد و کاربر جهت امور مسیریابی و روتینگ مجبور به استفاده از روتر مجزا با سریال مجزا می باشد.

This document provides the technical and cable specifications for the CAB-530MT serial cable.
There are no specific requirements for this document.
This document is not restricted to specific software and hardware versions.
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
For more information on document conventions, see the Cisco Technical Tips Conventions.
The cable gender for this product (part number 72-0797-01) is Male DB-60 to Male DB-25, mode - DTE only.

The CAB-530MT cable is used in the Cisco 7000 family, Cisco 4000 series, Cisco 3600 series, Cisco 2500 series, Cisco 1600 series, Cisco access servers, and AccessPro PC cards. This cable has a male DB-60 connector on the Cisco end and a male DB-25 connector on the network end.

The table below shows the EIA-530 DTE cable pinouts (DB-60 to DB-25).
Note: The arrows indicate signal direction:
|
60 Pin1 |
Signal |
25 Pin |
Signal |
Direction DTE DCE2 |
|
J1-11
J1-12 |
TxD/RxD+
TxD/RxD- |
J2-2
J2-14 |
BA(A), TxD+
BA(B), TxD- |
--->
---> |
|
J1-28
J1-27 |
RxD/TxD+
RxD/TxD- |
J2-3
J2-16 |
BA(A), RxD+
BB(B), RxD- |
<---
<--- |
|
J1-9
J1-10 |
RTS/CTS+
RTS/CTS- |
J2-4
J2-19 |
CA(A), RTS+
CA(B), RTS- |
--->
---> |
|
J1-1
J1-2 |
CTS/RTS+
CTS/RTS- |
J2-5
J2-13 |
CB(A), CTS+
CB(B), CTS- |
<---
<--- |
|
J1-3
J1-4 |
DSR/DTR+
DSR/DTR- |
J2-6
J2-22 |
CC(A), DSR+
CC(B), DSR- |
<---
<--- |
|
J1-46
J1-47 |
Shield_GND
MODE_2 |
J2-1
- |
Shield
- |
Shorted |
|
J1-48
J1-49 |
GND
MODE_1 |
-
- |
-
- |
Shorted |
|
J1-5
J1-6 |
DCD/DCD+
DCD/DCD- |
J2-8
J2-10 |
CF(A), DCD+
CF(B), DCD- |
<---
<--- |
|
J1-24
J1-23 |
TxC/RxC+
TxC/RxC- |
J2-15
J2-12 |
DB(A), TxC+
DB(B), TxC- |
<---
<--- |
|
J1-26
J1-25 |
RxC/TxCE+
RxC/TxCE- |
J2-17
J2-9 |
DD(A), RxC+
DD(B), RxC- |
<---
<--- |
|
J1-44
J1-45 |
LL/DCD
Circuit_GND |
J2-18
J2-7 |
LL
Circuit_ GND |
--->
- |
|
J1-7
J1-8 |
DTR/DSR+
DTR/DSR- |
J2-20
J2-23 |
CD(A), DTR+
CD(B), DTR- |
--->
---> |
|
J1-13
J1-14 |
TxCE/TxC+
TxCE/TxC- |
J2-24
J2-11 |
DA(A), TxCE+
DA(B), TxCE- |
--->
---> |
1Any pin not referenced is not connected.
2The EIA-530 interface cannot be operated in DCE mode. A DCE cable is not available for the EIA-530 interface
|